Ricoh Aficio 1013 Service Manual page 296

BIT SWITCHES
Communication Switch 14
No. FUNCTION
0 Inch-to-mm conversion during
transmission
0: Disabled (default)
1: Enabled
1 Inch/mm format informed to
the other terminal during
transmission
0: Always in inch format
1: Dependent on the other
terminal (default)
2 Not used
3 I/O rate for Detail reception
0: Off (Normal)
1: On (Double)
4 Positive response timing
when substitute reception is
disabled
0: When the fusing exit
sensor turns on
1: When all image data are
stored in the memory
B465
COMMENTS
0: Transmitting is always done in inch format.
1: If the other end only has mm-based resolution for
printing, the machine converts the scanned data to
mm-format before transmission.
0: The machine always informs the other terminal
that the resolution is in inch format and transmits
with the inch format.
1: The machine informs the other terminal that the
resolution is in mm format and transmits with the
inch format if the other end only has mm-based
resolution.
This setting is informed to the receiving terminal in
the pre-message protocol exchange (in the
DCS/NSS frames).
Do not change the setting.
1: Shortens receiving time for non-ECM
communication
Note: In most cases this setting should be left at 0.
Communication will fail if fusing warm-up time is
longer than the time it takes to receive the image.
This switch setting is effective when user parameter
switch 05 bit 0 is set to 0 (Substitute reception is
off).
0: The data is not stored in the SAF memory. The
machine sends the positive response to the other
end when the leading edge of the paper turns on
the fusing exit sensor. This informs the other end
of successful reception after the received image
data has already been printed.
1: The incoming data is stored in the SAF memory.
The machine sends the positive response to the
other end when all received image data have
been stored in the SAF memory. This sends the
positive response earlier than when this bit switch
is set to 0, but the page has not been printed yet.
The data goes to SAF, like for substitute
reception. However, it is different from substitute
reception, as follows:
• The machine rejects all incoming ringing
signals when the printer is out of order.
• The received image data are stored in the
memory even if no RTI/CSI is received.
5-24 SM