Ricoh Aficio 1013 Service Manual page 316

DEDICATED TRANSMISSION PARAMETERS
Switch 02
No. FUNCTION
0–3 Initial Tx modem rate
Bit 3 2 1 0 Setting (bps)
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 0 1
1 1 1 0
1 1 1 1
Other settings:
4, 5 Not used
6 AI short protocol
0: Off
1: Disabled
7 Not used
Switch 03
No. FUNCTION
0, 1 Inch-mm conversion before
transmission
Bit 1 Bit 0
0 0
0 1
1 0
1 1
2, 3 DIS/NSF detection method
Bit 3 Bit 2
0 0
0 1
1 0
1 1
B465
If training with a particular remote terminal always
takes too long, the initial modem rate may be too
Not used high. Reduce the initial Tx modem rate using these
2,400 bits.
4,800
7,200 For the settings 14.4 or kbps slower, Switch 04 bit 4
9,600 must be changed to 0.
12,000
14,400
If the setting is 'Disabled', the bit switch setting is
16,800
used.
19,200
21,600
Note: Do not use settings other than listed on the
24,000
left.
26,400
28,800
31,200
33,600
Disabled
Not used
Do not change the settings.
Refer to the Core Technology Manual for details
about AI Short Protocol.
If the setting is 'Disabled', the bit switch setting is
used.
Do not change the setting.
The machine uses inch-based resolutions for
scanning. If "inch only" is selected, the printed copy
Setting may be slightly distorted at the other end if that
Inch-mm machine uses mm-based resolutions.
conversion
available
If the setting is 'Disabled', the bit switch setting is
Inch only
used.
Not used
Disabled
(0, 1): Use this setting if echoes on the line are
Setting interfering with the setup protocol at the start of
First DIS or transmission. The machine will then wait for the
NSF second DIS or NSF before sending DCS or NSS.
Second DIS or
NSF
If the setting is 'Disabled', the bit switch setting is
Not used
used.
Disabled
5-44
COMMENTS
COMMENTS
SM