Ricoh Aficio 1013 Service Manual page 164

IMAGE PROCESSING
6.8.5 MODE ADJUSTMENTS
As a service person, you can use SPs 4-922 to 4-966 to further customize each of
these original modes to meet specific user requirements. If the user is
experiencing a problem with copy or fax quality, however, SP-based adjustment
should be the last step. Always proceed as follows:
1. First, try changing the density notch setting.
If that doesn't resolve the problem, then...
2. Try selecting a different original mode.
If that also doesn't resolve the problem, then...
3. Try customizing the relevant original mode with SPs.
To customize...
First use SP4-921 to select the original mode that you wish to customize. Then
enter the relevant customizations using SP4-922 to SP4-966. Refer to Section 5
for general information about the adjustments you can make .
Note the following points:
• All SP settings are relative to the selected original mode. If you set the SP value
to "0", the machine will use the default processing for that mode.
• If you enter an SP customization setting for an original mode that does not
support that customization, the entry will have no meaning.
B044/B045/B046 6-22 SM