Ricoh Aficio 1013 Service Manual page 282

BIT SWITCHES
System Switch 03
No.
0–7 Length of time that RDS is
temporarily switched on when bits 6
and 7 of System Switch 02 are set
to "User selectable"
System Switch 04
No.
0–2 Not used
3 Dedicated transmission parameter
programming
0: Disabled 1: Enabled
4 Not used
5 Replacement level for the
maintenance kits
0: User
6 CSI programming level
0: User level 1: Service level
7 Telephone line type programming
mode
0: User level 1: Service level
System Switch 05
No.
0–7 Not used
B465
FUNCTION
FUNCTION
1: Service
FUNCTION
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
Do not change these settings.
Set this bit to 1 before changing any dedicated
transmission parameters.
Do not change the setting.
0: The machine asks the user to replace the
parts in the ADF maintenance kit after
45,000 scans with the ADF.
After the user replaces the parts, the machine
asks the user if they have been replaced or
not. After the user answers yes, the user has
to reset the roller counter using the key
operator tools.
The replacement counter is programmed at
the following addresses:
ADF kit counter: 4002D0 to 4002D3(H)
Refer to section 5.5 for more details.
1: The machine will not ask the user to
replace the maintenance kits.
1: Only a service function can program the
CSI.
1: Only a service function can program the
telephone line type selection.
Do not change these settings.
5-10
COMMENTS
COMMENTS
COMMENTS
SM