Start/Stop Mode - Adtech iMASTER – A1 Series User Manual

A1-User's Manual

8.2.10 Start/Stop mode

21.01 Torque boost mode

0: Manual torque boost ----- Initial value

1: Automatic torque boost

Select a torque boost mode
It is working only V/F mode at
starting torque.
'21.01' (torque boost mode) = 1
If
1.
2.
3.
21.02 Magnetization time

Range: 0.0 ~ 3000 Sec in 0.1 Sec

Initial value: 0.0 Sec

Set the time for DC Injection Braking duration before VFD start
It will be operated when
have set above zero
Run command
21.03 Magnetization Level

Range: 0.0 ~ 200.0 % in 0.1 %

Initial value: 30.0 %

Set the level for DC Injection Braking duration before VFD start
21.04 Stop mode

0: Ramp to Stop (Deceleration) ----- Initial value

1: Coast to Stop (Free Run to Stop)

Select a stop method when Stop command is given.
Put the plate data of motor in
Get the motor data by the Auto Tuning
'99.09' (Motor data selection)
Use auto tuning data at
'21.02' (Magnetization time)
Frequency
Free run
DC current
21.02 (Magnetization time)
'98.01' (Motor control mode)
, recommended the following
'99.01' ~ '99.07'
and
21.03 (Magnetization level)
AC current
ON
１１１
and will compensate for
'21.03' (Magnetization level)
Frequency