Remote Site: Corporate Access - 3Com OfficeConnect Remote 812 Cli User's Manual

A-4 A A: OFFICECONNECT REMOTE 812 SAMPLE CONFIGURATION
PPENDIX
dynamically learn the addresses for two remote DNS Servers. The login name for
this account is "internet-user" and the password is "1a2b3c".
Port Address Translation will be enabled, allowing all the workstations on our local
LAN to share one public IP address. This Remote Site will be used as our default
gateway. The ATM virtual channel is VPI 0 and VCI 32 and the Peak Cell Rate is set
to the default access rate.
This remote site is configured with the following commands:
add vc Internet
set vc Internet ip enable ipx disable bridging disable
set vc Internet network_service ppp
set vc Internet send_name internet-user send_password 1a2b3c
set vc Internet atm vpi 0 vci 32 category_of_service unspecified pcr 0
set vc Internet address_selection negotiate
set vc Internet local_ip_address 255.255.255.255
set vc Internet nat enable
set vc Internet ip_routing listen
set vc Internet default_route_option enable
enable vc Internet
Remote Site: Corporate In this section, the Remote Site to the Corporate office is defined with the
Access identifying name of "corp-net". IP and IPX are both routed over this remote site
and all other protocols are bridged. The configured network service is RFC 1483
and the remote router address is specified (192.168.1.254). The WAN IPX
interface is Unnumbered.
Port Address Translation is disabled on this Remote Site Profile. The ATM virtual
channel is VPI 0 and VCI 33 and the Peak Cell Rate is set to the default access rate.
This remote site is configured with the following commands:
add vc corp-net
set vc corp-net ip enable ipx enable bridging enable
set vc corp-net network_service rfc_1483
set vc corp-net atm vpi 0 vci 33 category_of_service unspecified pcr 0
set vc corp-net remote_ip_address 192.168.1.254
set vc corp-net local_ip_address 0.0.0.0
set vc corp-net nat_option disable