Tunnel Commands - 3Com OfficeConnect Remote 812 Cli User's Manual

6-8 C 6: M
HAPTER ANUAL

Tunnel Commands

add tunnel <tunnel_name>
delete tunnel
<tunnel_name>
enable tunnel
<tunnel_name>
disable tunnel
<tunnel_name>
list tunnel
show tunnel
<tunnel_name>
set tunnel <tunnel_name>
S
ETUP
be blank (assigned with the value ""). You can change the PASSWORD and
SEND_PASSWORD using the SET TUNNEL [PASSWORD | SEND_PASSWORD]
command. You must change the SEND_PASSWORD (to the appropriate
authentication password value expected by the VPN Server) using the SET TUNNEL
< tunnel_name> SEND_PASSWORD command. You may optionally change the
PASSWORD using the SET TUNNEL < tunnel_name> PASSWORD command.
You must make sure that the tunnel is disabled before you attempt to change the
passwords.
The commands presented in this section enable you to display tunnel information,
enable and disable a tunnel, and set the tunnel parameters shown in
Use this command to set up a VPN tunnel with the default values shown
Optionally, specify the server end point and the remote ip address as follows:
SERVER_END_POINT <HOST_NAME OR IP_ADDR>
A remote_ip_address value specified as an add tunnel command option should be
255.255.255.255 (this is the default value).
Use this command to delete the tunnel.
Use this command to activate the tunnel.
Use this command to deactivate the tunnel.
Use this command to list the name and status of tunnels.
Use this command to display the parameter values currently defined for the
specified tunnel.
Use this command to modify any of the parameters of the tunnel. The following is
a list of set tunnel parameters and supported values:
Table 6-2 812 Set Tunnel Parameters and Supported Values
Parameter
ENCRYPTION_ALGORITHM
MTU
TUNNEL_TYPE
Supported Value Remarks
NONE
AUTO
MICROSOFT_128BIT
MICROSOFT_40BIT
MICROSOFT_56BIT
REQUIRED
1400
PPTP, L2TP
Table 6-2.
Table 6-1.