List Interfaces; List Ip Addresses; List Ip Arp; List Ip Interface_Block - 3Com OfficeConnect Remote 812 Cli User's Manual

list interfaces

list ip addresses

list ip arp

list ip interface_block

list ip networks

list ip routes

Displays the installed interfaces, along with their operational status, administration
status, and interface index. If an interface is down, you can use enable interface to
try to bring it up. The command lists:
Index - number used to identify the interfaces position in the table


Name - interface name: eth:1, DA:1 or loopback


Oper Status - current, operating status of interface; UP or DOWN


Admin Status - administrative status you designated interface to be, up or


down. If it doesn't match Oper Status, a problem exists with the interface.
Displays the IP address for each interface. It lists:
Address - IP address of the interface


Bcast Algo - broadcast algorithm used


Reassembly Max Size - maximum allowable size of packet that can be


reassembled from a fragmented packet
Interface - interface this IP address uses to connect to the system


Displays the contents of the ARP cache. It lists:
IP Address - IP address for this entry


Phys Address - MAC address that the IP address maps to


Type - interface type: Ethernet or Token Ring


If Name - eth:1, DA:1 or loopback


Displays the IP addresses associated with each system interface. If the interface has
a point-to-point connection, then the neighbor field contains the address of the
remote system. This command lists:
Address - IP address of the interface


Neighbor - IP address of the remote system


Status - status of the connection; ENABLED or DISABLED


Interface - eth:1, DA:1 or loopback


Displays all the IP networks you previously defined using the add ip network
command. It also lists:
Name - network designation


Prot - always the IP protocol


Int - name of the interface this network runs on


State - state of the network; ENABLED or DISABLED


Type - STATIC or DYNAMIC network


Network Address - address of the IP network


Displays all the statically defined IP routes that you previously defined using the
add ip route command. It lists:
Destination - IP address that the route resolves to


CLI Commands B-19