Set User <User_Name - 3Com OfficeConnect Remote 812 Cli User's Manual

set user <user_name>
Table 6-7 812 Set Tunnel Parameters and Supported Values
Parameter
SEND_PASSWORD
ENCRYPTION_ALGORITHM
MTU
SEND_NAME
NAT_OPTION
LOCAL_IP_ADDRESS
REMOTE_IP_ADDRESS
message ["message"]


password [password]


session_timeout [seconds]


tcp_port [tcp_port]


terminal_type


Modifies user parameters.
Parameter Description
<user_name> Name of user, previously defined using add user. Limit of 32 characters.
message Message presented to a dial-in user.
password User's password, up to 15 ASCII characters. Value is required.
Supported Value Remarks
<password> The SEND_PASSWORD
must match the
authentication password
on the VPN server. You
must change the default
SEND_PASSWORD using
the SET TUNNEL
command.
NONE
AUTO
MICROSOFT_128BIT
MICROSOFT_40BIT
MICROSOFT_56BIT
REQUIRED
1400
<name> The SEND_NAME must
correspond with the
authentication name on
the VPN server. If you do
not specify <name>, the
system sets the value for
this field to <tunnel
name>.
PAT
<ip_address> 255.255.255.255 is the
recommended setting for
LOCAL_IP_ADDRESS
<ip_address> 255.255.255.255 is the
recommended setting for
REMOTE_IP_ADDRESS
CLI Commands B-35