Agilent Technologies BenchCel User Manual page 56

3 Installing BenchCel Microplate Handler
Mounting the robot
WAR NING
Related information
46
Figure
BenchCel robot head in up position: (
1
The robot head may not remain in the up position. The robot head can drop,
potentially pinching your fingers. Ensure that you support the weight of the robot
head while it is in the up position.
8
Gently lower the robot head onto the base.
9
To secure the front panel to the robot base, use a 2-mm hex wrench to install the
two screws.
For more information about...
Installation requirements
Installing the BenchCel Microplate
Handler
1
) mounting screw holes and (
2
See...
"Verifying laboratory requirements" on
page 37
"Installation workflow" on page 36
BenchCel Microplate Handler User Guide
2
) front panel