Check The Position Of The Detergent Flap; Setting A Programme; Starting A Programme - John Lewis JLBIWD1405 User Manual

Always follow the instructions that
you find on the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum indicated
level ( ). This quantity will
however guarantee the best
washing results.
After a washing cycle, if necessary,
remove any detergent residue from
the detergent dispenser.
Check the position of the
detergent flap
1. Pull out the detergent dispenser until it stops.
2. Press the lever down to remove the dispenser.
3. To use powder detergent, turn the flap up.
4. To use liquid detergent, turn the flap down.
With the flap in the position DOWN:
• Do not use gelatinous or thick liquid
detergents.
Washer Dryer User Manual
• Do not exceed to liquid detergent dose
indicated on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.

Setting a programme

1. Turn the programme dial to select the desired
washing programme.
The indicator of Mode - Wash button
illuminates.
The indicator of the Start/Pause button flashes.
The display shows an indicative programme
duration and the maximum load.
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds and the
display shows

Starting a programme

Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. the door is open).
The related indicator stops flashing and stays on.
.
39