Dial And Buttons; Introduction; On/Off; Mode - John Lewis JLBIWD1405 User Manual

Table of Contents

Advertisement

Dial and buttons

Introduction

The options/functions are not
available with all washing
programmes. Check the
compatibility between options/
functions and washing programmes
in the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you to set
incompatible options/functions.

On/Off

Press this button for a few seconds to activate
or deactivate the appliance. Two different tunes
sound while switching the appliance on or off.
As the Stand-by function automatically
deactivates the appliance after several minutes
to reduce the energy consumption, you may
need to activate the appliance again.
For more details, refer to Stand-by paragraph in
Daily Use chapter.

Mode

Thanks to this button, a cycle can perform:
• Only washing: Mode - Wash indicator is on
(default mode).
• Washing and drying: Mode - Wash and
Mode - Dry indicators are on.
• Only drying: Mode - Dry indicator is on.

Temp

When you select a washing programme, the
appliance automatically proposes a default
temperature.
Washer Dryer User Manual
Tap on this button to change the water
temperature.
The indicator of the set temperature comes on.
The indicator Cold corresponds to cold water.

Spin

When you set a programme, the appliance
automatically sets the maximum spin speed
allowed, except for programme Denim. With
this option you can decrease the default spin
speed.
Touch repeatedly this button to:
• Decrease the spin speed. The display shows
only the spin speeds available for the set
programme.
• Additional spin options No Spin
Set this option to deactivate all spin phases. The
appliance performs the only draining phase of
the selected washing programme. Set this
option for very delicate fabrics. The rinses
phase uses more water for some washing
programmes
• Activate the Rinse Hold
The final spin is not performed. The water of
the last rinse is not drained out to prevent the
fabrics from creasing. The washing programme
ends with water in the drum.
The indicator
locked and the drum turns regularly to reduce
creasing. You must drain the water to unlock
the door.
If you touch the Start/Pause button, the
appliance performs the spinning phase and
drains the water.
The appliance empties the
water out automatically after 18
hours approximately.
option.
is on display. The door stays
.
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents