Cleaning The Inlet Hose And The Valve Filter; Emergency Drain; Frost Precautions - John Lewis JLBIWD1405 User Manual

Cleaning the inlet hose and the valve filter

1
2
3

Emergency drain

If the appliance cannot drain the water, carry
out the same procedure, described in 'Cleaning
the drain pump' paragraph. If necessary, clean
the pump.
When you drain the water with the emergency
drain procedure, you must activate the drain
system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.

Frost precautions

If the appliance is installed in an area where the
temperature can reach values around 0° C or
drop below, remove the remaining water from
the inlet hose and the drain pump.
56
20°
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
Warning! Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
45°
Washer Dryer User Manual