Emergency Door Opening - John Lewis JLBIWD1405 User Manual

Problem
The appliance does not dry or
does not dry correctly.
The laundry is full of different
colours fluff.
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.

Emergency door opening

In case of power failure or functioning failure the
appliance door remains locked. The washing
programme continues when the power is
restored. If the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
Caution! Risk of burns! Make
sure that the water
temperature is not too high
and the laundry is not hot. If
necessary, wait until they cool
down.
Caution! Risk of injury! Make
sure that the drum is not
rotating. If necessary, wait
until the drum stops rotating.
Make sure that the water
level inside the drum is not
too high. If necessary,
proceed with an emergency
drain (refer to «Emergency
drain» in «Care and cleaning»
chapter).
To open the door, proceed as follows:
60
Possible solution
• Turn the water tap on.
• Make sure the drain filter is not clogged.
• Reduce the laundry load.
• Make sure you have set the correct cycle. if necessary, set again a short
drying time.
The fabrics washed in the previous cycle released fluff of a different colour:
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the special programme
to clean it (refer to "Fluff in the fabrics" for more details).
1. Press the On/Off button to switch the
appliance off.
2. Disconnect the mains plug from the mains
socket.
3. Pull the emergency unlock trigger downward
once. Pull it once again, keep it tensed and, in
the meanwhile, open the appliance door. The
emergency unlock trigger is located where
indicated by the following picture.
4. Take out the laundry and then close the
appliance door.
Washer Dryer User Manual