Starting A Programme With The Delay Start; The Sensicare System Load Detection; Interrupting A Programme And Changing The Options - John Lewis JLBIWD1405 User Manual

The programme starts, the door is locked. The
display shows the indicator
The drain pump can operate
shortly before the appliance fills
water.
Starting a programme with
the delay start
1. Touch the Delay start button repeatedly until
the display shows the desired delay time. The
related indicator comes on.
2. Touch the Start/Pause button. The appliance
door locks and starts the countdown of the
delay start. The display shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
2. Touch the Delay start button repeatedly until
the display shows .
3. Touch the Start/Pause button again to start
the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
2. Touch the Delay start button repeatedly until
the display shows the desired delay time.
3. Touch the Start/Pause button again to start
the new countdown.
The SensiCare System load
detection
The programme duration in the
display is referred to a medium/
high load.
40
.
After touching the Start/Pause button, the
SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first 30
seconds. During this phase the Reduce time
bars placed below the time digits play a
simple animation, the drum rotates shortly.
2. The programme duration will be adjusted
accordingly and could increase or decrease.
After further 30 seconds, the water filling
starts.
At the end of the load detection, in case of
drum overload, the indicator
in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the exceeding
garments.
Once removed the exceeding garments, touch
the Start/Pause button to start the programme
again. The SensiCare phase can be repeated up
to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts anyway,
despite the overload. In this case, it will be not
possible to guarantee the best washing results.
About 20 minutes after the
programme start, the programme
duration could be adjusted again
depending on the capacity of water
absorption of the fabrics.
The SensiCare detection is carried
out with complete washing
programmes only and if the
programme duration has not been
reduced by means of the Reduce
time button.
Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start/Pause button.
is flashing
Washer Dryer User Manual