Installation Of The Non-Contact Cone; Charging The Demetra Scope - Barco Demetra User Manual

Hide thumbs Also See for Demetra:

Table of Contents

Installation and configuration

Image 2-10

It may be needed to firmly pull the grip to separate it from the Demetra Scope head.

2.2.3 Installation of the non-contact cone

Non-contact cone

When capturing dermoscopic images with the Demetra Scope in non-contact mode, the non-contact cone can

be installed on the Demetra Scope head. This protects the contact glass in the head of the Demetra Scope

from any contamination due to possible skin infections (lesion).

Install the non-contact cone on the head of the Demetra Scope. The notch in the non-contact cone must be

fitted on the secondary camera. The non-contact cone is held in place safely through a magnetic attachment.

Procedure

Connect the adapter to the battery charging station. Route the adapter cable through the notch at the

bottom of the battery charging station to put the charging station in a stable position.

Place the adapter plug for your country (USA, EU or UK) into the adapter such that the plug fits into the

foreseen slots. Slide the plug downwards until it clicks.

Plug the adapter into the socket.

Place the complete Demetra Scope (with grip installed) or the separate grip in the battery charging station.

Make sure that the notches at the bottom of the grip are properly installed on the protrusions of the battery

charging station. The complete Demetra Scope (with grip installed) or the separate grip is held in place

safely in the battery charging station through a magnetic attachment.

The LED on the grip is slowly blinking green during charging. As soon as the LED is steady green,

charging is complete.

Complete charging time (from empty battery to fully charged battery) is approximately 3 hours.

For use only with the delivered adapter: model ATM012T-W051V, Adapter Technology Co., Ltd.

The Demetra Scope head also includes a battery. To charge the full battery capacity, install the

complete Demetra Scope (with grip installed) in the battery charging station.

Install the battery charging station on a flat, stable surface near an easily accessible socket. Make

sure the adapter cable is routed towards the socket in a safe way to avoid damage to the cable and/

or charging station.

K5902200 /02AC

Barco Demetra

Table of Contents