Table of Contents
Advertisement
2. INSTALLATION
W
ARNING
your monitor. Please refer to the dedicated chapter in this user guide.
W
ARNING
complete setup must be tested before taking into operation.
C
AUTION
tion of all cables, to avoid unwanted detachment.
C
AUTION
2.1
Cable connections
Opening and closing the rear cover
1. Remove the two rubber-caps which cover the fixation screws.
2. Remove the two fixation screws and remove the rear cover from the MUIP-2112.
Image 2-1
3. To properly close the rear cover, first route the cables as described in "Cable routing", page 8 . Install
the rear cover and follow the above steps in reverse order.
Power and LAN connection
The MUIP-2112 Computing Touch-Screen Module working as an intelligent User-Interface is usually con-
nected to the system via Ethernet LAN connection and / or USB interface connection.
1. Connect the power connector to the power jack input.
K5902132 (451920612532) MUIP-2112 30/11/2017
:
Read all the important safety information before installing and operating
:
Sufficient expertise is required to install this equipment. All devices and
:
When the display is assembled in the medical system, take care of the fixa-
:
The equipment is not intended to be sterilized.
2. Installation
7
Advertisement
Table of Contents
