2.3 Setup of Demetra Scope
2.3.1 Configuration
Procedure
A good Wifi connection is required for sufficient performance of your Demetra Scope.
The Demetra Scope battery must be fully charged before initial setup. Charge for a minimum of 2
hours before initial use.
First perform the configuration (as admin) procedure of the Demetra Web Application (see
"Configuration (admin)", page 13).
1.
Press the On/Off button to turn on the Demetra Scope. The welcome screen will be shown.
2.
Check to make sure that the grip is attached to the head of the device and the locking ring is fully closed,
then proceed to the next step.
3.
Follow the instructions on the display screen to link your device to your customer account (organization).
4.
Scan the QR code shown in the Demetra Web Application with the Demetra Scope.
5.
When the QR code was scanned successfully, the Demetra Scope needs to be connected to a Wifi
network.
6.
Once the Wifi connection is established, the Demetra Scope is linked to the customer account and the
device is ready for use.
2.3.2 Status bar
Overview
The status bar at the top right corner of the Demetra Scope display can be swiped down to:
•
Log out the current user
•
Access the Settings menu (including legal information)
•
View the remaining battery level
•
Access the network settings
•
View the cloud synchronization status
•
View patient information and/or select a(nother) patient
Image 2-11
Installation and configuration
K5902200 /02AC
Barco Demetra
19