Instructions - Barco Demetra User Manual

Cleaning and disinfection

7.1 Instructions

To disinfect the contact glass and biocompatible plastic of the Demetra Scope
The exterior and contact glass of your Demetra Scope may be cleaned and disinfected by wiping it with a
recognized product for disinfection. Read and follow all label instructions on the disinfection product.
Disinfection is required at least before every new patient examination, and after touching breached or
compromised skin surfaces with the device. Do not use abrasive material on any part of the equipment or
immerse the device in liquid. Do not autoclave.
The following products can be used for disinfection:
Disinfection products:
• Clinell wipes
• Cleaning agent: Neodisher® MediClean
Disinfection products based on following substances:
• Isopropyl alcohol <70%
• Ethanol based < 90%
To clean the contact glass of the Demetra Scope
The contact glass should be treated as high quality photographic equipment and should be cleaned with
standard cleaning equipment and protected from harmful chemicals.
To clean the display of the Demetra Scope
Clean the display using a sponge, cleaning cloth or soft tissue, lightly moistened with a recognized cleaning
product for medical equipment. Read and follow all label instructions on the cleaning product. In case of doubt
about a certain cleaning product, use plain water.
Do not use following products:
• Alcohol/solvents at higher concentration > 5%
• Strong alkalis (lye), strong solvents
• Highly acidic detergents
• Detergents with fluoride
• Detergents with ammonia
• Detergents with abrasives
• Steel wool
• Sponge with abrasives
• Steel blades
• Cloth with steel thread
CAUTION: Take care not to damage or scratch the display. Be careful with rings or other jewelry
and do not apply excessive pressure on the display.
CAUTION: Do not apply or spray liquid directly to the display as excess liquid may cause damage
to internal electronics. Instead, apply the liquid to a cleaning cloth.
42 K5902200 /02AC Barco Demetra