Specifying The Registration Mark Offset - GRAPHTEC FC4200-50 User Manual

After the sensor reads the cross symbol, a cross symbol for use in adjustment is plotted using the pen
in Pen Holder 1 (see the figure below).
Value for Y-axis
distance correction
The 2nd cross plotted
(6) After the sensor reads the cross symbol plotted for use in adjustment, the menu below appears.
FORCE
F1
CURRENT VALUES
X=
F2
SPEED
(7) Press the (X=) or
F2
To change the corrective value for sensor adjustment, use the
correction is required, skip to Step (8)).
(8) When the displayed setting is satisfactory, press the
(9) Press the PAUSE key to return the plotter to READY status.

6.11.3 Specifying the Registration MARK OFFSET

Unless the origin point has been moved to a new position, it is located at the lower left corner of the
effective cutting/plotting area. Use the MARK OFFSET function when you wish to move the origin of the
registration mark.
Registration mark pattern 1
Origin
Setting Procedure
(1) Press the PAUSE key, then press the
FORCE
F1
MARK
CLEAR
F2
SPEED
Value for X-axis
distance correction
OFFSET
0 Y= 0
QUALITY
(Y=) key to move the
F4
OFFSET
PEN U/D
SELECT PEN
QUALITY
F3
F4
blinking cursor to the value to be corrected.
ENTER key to register your setting.
Registration mark pattern 2
Origin
NEXT PAGE key until the menu below appears.
F3
F4
6 – 25
and POSITION keys. (If no