GRAPHTEC FC4200-50 User Manual page 64

(5) After the ENTER key is pressed in Step (4) while the second menu is being displayed, the plotter
returns to READY status.
Specifying Two-Point (2 POINT) Recognition
This following procedure describes how to align the coordinate axes based on two points. In this mode, the
plotter reads two registration marks in the X-axis direction and then corrects the tilt in the X axis and adjusts
the distance precision.
NOTE
When the MARK DIST. ADJ. setting is OFF, 1 mm (any value of 1 mm or less is rounded off) or 5 mm
(any value of 5 mm or less is rounded off), the menu for inputting a corrective value shown in Step (3)
does not appear.
Setting Procedure
(1) Press the ORIGIN key to display the prompt below.
FORCE
F1
1
2 SEL. MOVE LENG 3
F2
SPEED
(2) To return the pen carriage to the initial point for starting registration mark detection, press the
(DEFAULT) key. To adjust the position of the registration mark origin, use the
POSITION keys to move the pen's tip within the area of the desired origin position (see the figures
below).
Registration mark pattern 1
Desired origin (A)
Move the pen's tip within this area
To begin adjustment, press the
sponding number for the mark space interval registered for the Mark Move Dist. setting. The message
below appears.
FORCE
F1
F2
SPEED
DEFAULT
Point (B)
(No. = 1),
F1
WAIT .....
OFFSET
F3
F4
QUALITY
Registration mark pattern 2
Desired origin (A)
Move the pen's tip within this area
(No. = 2) or
F2
OFFSET
F3
F4
QUALITY
6 – 18
,
Point (B)
(No. = 3) key to select the corre-
F4
F3
, ,