Clearing The Plotter's Internal Buffer Memory - GRAPHTEC FC4200-50 User Manual

5.5 Clearing the Plotter's Internal Buffer Memory

The BUFFER CLEAR function allows you to clear cutting data that has been saved in the plotter's internal
buffer memory.
Setting Procedure
(1) Consecutively press the
FORCE
F1
MARK
CLEAR
F2
SPEED
(2) Press the
F2
FORCE
F1
BUFFER CLEAR?
YES
F2
SPEED
(3) To clear existing data in the internal buffer memory, press the
clear the data, press the
(4) Press the PAUSE key to return the plotter to READY status.
CAUTION
• Only use this function after the plotter has finished receiving all of the data sent from the computer.
• If you perform a BUFFER CLEAR operation while the computer is in the process of sending data,
the data received in the plotter's internal buffer memory before the plotter was switched to PAUSE
status will be cleared, but the plotter will output any data received after it returns to READY status
from PAUSE status. In the latter case, the plotter may suddenly start operation, so be sure to keep
hands and other parts of the body away from the pen holder.
If you select NO in response to the "BUFFER CLEAR?" prompt, the plotter will resume the operation which
you suspended by pressing the PAUSE key.
PAUSE key and
PEN U/D
SELECT PEN
(BUFFER CLEAR) key to display the menu below.
(NO) key.
F4
NEXT PAGE key to display the menu below.
OFFSET
F3
F4
QUALITY
OFFSET
F3
NO
F4
QUALITY
5 – 8
(YES) key. If you do not wish to
F2