How To Stop The Controller - Toshiba nv Series Instruction Manual

Chapter 4 Starting and Stopping
4.5

How to Stop the Controller

Stop the unified controller according to the following procedure.
44
6F8C1220
Change the operation mode switch of the controller module to
"HALT".
Turn off the external power to supply the TC-net I/O unit and the
load power.
If the external power cannot be shared with the load power, they should be
turned off simultaneously (or the load power and then the external power).
Turn off the power of the controller unit.
Turn off the load power before turning on the power
CAUTION
of nv series for the safety of the system.
Failure to observe it may cause an accident and damage
on the machine.
Use the external power supplied to the I/O module with
the load power if possible. If it is not possible, configure
the system so that the external power and the load power
turn off simultaneously.
Mandatory