Toshiba IPedge IP5000 Series Installation Instructions Manual page 47

PREFERENCE
CO Park & Hold
MW & DND Dial Tone
Activate Message Waiting
Tenant Number
Hook-Switch Recall
Auto-Campon to PDN
IPT Installation Manual July, 2013
Enabled: When this station parks a line call, CO or GCO buttons of the
parked line that appear on other stations will be on hold. This will allow
the other stations to press the CO or GCO button to pickup the parked
call.
Disabled: When this station parks a line call, CO or GCO buttons of the
parked line that appear on other stations will appear busy. This will
prevent the other stations to press the CO or GCO button to pickup the
parked call.
Enabled or Disabled (default = Disabled)
Enable: When you access internal dial tone, your telephone will receive
stuttered dial tone when it has a message waiting indication; and you will
receive a busy tone burst when your telephone is in the DND mode.
Disable: This station will receive normal dial tone when it has a message
waiting or when it is in the DND mode.
Enabled or Disabled (default = Enabled)
Enable: This station is allowed to activate station-to-station message
waiting on other stations by dialing the other station number plus 7, 8, or
9, or by pressing the Msg key.
Disable: This station can not activate station-to-station message waiting
on other stations by dialing the station number plus 7, 8, 9, or by pressing
the Msg key.
This parameter does not apply to Voice Mail ports; they use the special
Message Waiting access codes.
Enabled or Disabled (default = Enabled)
Enter the Tenant number to which this PDN should be assigned.
1~ 8 (default = 1)
Not Applicable
Enable - to allow auto-campon to this PDN when busy and called by a CO
line even if the CO line group has auto-campon disabled in Trunk, Trunk
Groups, Incoming, Show advanced configuration.
Disable - to not allow auto-campon to this PDN when called by a CO line
if the CO line group has auto-campon disabled in Program Trunk, Trunk
Groups, Incoming, Show advanced configuration.
Note: Auto-campon will always occur on the PDN if the calling CO
line group has auto-campon enabled in Trunk, Trunk Groups,
Incoming, Show advanced configuration regardless of how
this option is set.
Auto-campon will be applied or not to PhDNs according to the
PhDN owner PDN setting for this option.
Enabled or Disabled (default = Enabled)
CO Park & Hold
2-7