Table of Contents
Advertisement
200
STARTING AND OPERATING
T
L
S
O
URNING
ANE
ENSE
N
The LaneSense button is located on
the switch panel below the Uconnect
display.
NOTE:
If your vehicle is equipped with a 12-inch
Uconnect Display screen, the LaneSense button
is located above the display.
To turn the LaneSense system on, push the
LaneSense button (LED turns off). A
"LaneSense On" message is shown in the
instrument cluster display.
To turn the LaneSense system off, push the
LaneSense button again (LED turns on).
NOTE:
The LaneSense system will retain the last
system state on or off from the last ignition
cycle when the ignition is placed in the ON/RUN
position.
O
O
L
S
R
FF
ANE
ENSE
The LaneSense system will indicate the current
lane drift condition through the instrument
cluster display.
When the LaneSense system is on, the lane
lines are gray when both of the lane boundaries
have not been detected and the LaneSense
telltale
System ON (Gray Lines) With White Telltale
Left Lane Departure — Only Left Lane Detected
When the LaneSense system is on, the Lane-
Sense Telltale
left lane marking has been detected and the
system is ready to provide visual warnings in
the instrument cluster display if an uninten-
tional lane departure occurs on the left side.
W
M
ARNING
ESSAGE
is solid white.
is solid white when only the
When the LaneSense system senses the lane
has been approached and is in a lane depar-
ture situation, the visual warning in the
instrument cluster display will show the left
lane line flashing yellow (on/off). The Lane-
Sense telltale
changes from solid white to
flashing yellow.
Lane Approached (Flashing Yellow Lane Line) With Yel-
low Telltale
NOTE:
The LaneSense system operates with similar
behavior for a right lane departure when only
the right lane marking has been detected.
Advertisement
Table of Contents
