Table of Contents
Advertisement
440
SERVICING AND MAINTENANCE
4. Reach behind the headlamp and disengage
the access cover by rotating counter-
clockwise.
5. Disconnect the internal lamp wiring harness
connector from the high beam bulb.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened
bulb life will result.
Always use the correct bulb size and type
for replacement. An incorrect bulb size or
type may overheat and cause damage to
the lamp, the bulb socket, or the lamp
wiring.
6. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the lamp.
7. Pull the bulb straight out from the housing.
8. Reverse the procedure for installation of
new bulb and cover.
Front Park And Turn
See below steps to replace:
1. Open the hood.
2. Disconnect and isolate the negative battery
cable.
3. Locate the park and turn socket, which can
be found on the back side of the
headlamps.
Park And Turn Socket
4. Reach behind the headlamp and unlock the
park and turn socket from the lamp by
rotating counterclockwise a quarter turn.
5. Pull the bulb straight out from the housing.
6. Separate the bulb from the socket without
twisting.
7. Reverse the procedure for installation of
new bulb and covers.
Side Marker Lamp
See below steps to replace:
1. Open the hood.
2. Disconnect and isolate the negative battery
cable.
3. Locate the side marker lamp, which can be
found on the back side of the headlamps.
Side Marker Lamp
Advertisement
Table of Contents
