Table of Contents
Advertisement
220
STARTING AND OPERATING
Once calibrated the driver can shift to PARK,
push the button on top of the TRSC knob and
activate the feature. The knob is then turned
either to the left or right depending on what
direction the driver wants the trailer to go.
Trailer Reverse Steering Control Knob
NOTE:
When steering the trailer with the knob, remove
hands from the steering wheel.
There is also a holdover state where if during an
active trailer steering maneuver, the driver
shifts to NEURAL or DRIVE to straighten the
trailer, the driver may shift back to REVERSE
and not need to reactivate the feature. However
the feature will cancel after 10 seconds or when
the vehicle speed reaches 8 mph (12 km/h).
Instrument Cluster Messages:
"Drive forward to calibrate trailer" will display
when a trailer is not calibrated and the
vehicle is at standstill while the button is
pushed.
"Calibrating trailer" will display when the
trailer is not calibrated and the vehicle is
moving while the button is pushed.
"To activate trailer steering shift to P" will
display when the trailer is calibrated success-
fully and the vehicle is not in PARK.
"Trailer Steering ready, shift to reverse" will
display when the button is pushed, trailer is
calibrated and the vehicle is in PARK.
"Trailer steering active" will display after the
driver shifts to REVERSE and indicates the
feature is active.
"Trailer Steering Unavailable" will display if
there is a fault in the system preventing acti-
vation, the driver's door is open, the driver's
seat belt is unbuckled, or the tailgate is open.
Other reasons the feature may cancel:
The driver overrides steering by placing
hands on the steering wheel.
Trailer tracking is lost.
If the trailer angle becomes excessive, the
brakes apply bringing the vehicle to a stop
and then applying the parking brake.
Trailer steering button is pushed while active.
Vehicle speed goes over 8 mph (12 km/h).
Driver door is open and seat belt is
unbuckled.
Transmission shifted to PARK.
Trailer Memory
The trailer steering system can remember up to
five trailers, so recalibration will not be
necessary.
To store a trailer to memory, calibrate the trailer
and then allow the vehicle to be off for a period
of time. The next time the vehicle is started,
place the vehicle in DRIVE and drive a short
distance. The trailer system can then be
activated.
Advertisement
Table of Contents
