Enabling And Disabling The Parksense Active Park Assist System - RAM 1500 2WD 2021 Owner's Manual

196 STARTING AND OPERATING
New vehicles from the dealership must have

at least 30 miles (48 km) accumulated
before the ParkSense Active Park Assist
system is fully calibrated and performs accu-
rately. This is due to the system's dynamic
vehicle calibration to improve the perfor-
mance of the feature.
The driver must control the vehicle's brakes.

The automatic emergency braking feature is
NOT intended to substitute for the driver
during REVERSE maneuvers.
E A D
NABLING ND ISABLING
P S A P
ARK ENSE CTIVE ARK
S
YSTEM
The ParkSense Active Park Assist
system can be enabled and disabled
with the ParkSense Active Park Assist
switch, located on the switch panel
below the Uconnect display.
NOTE:
If your vehicle is equipped with a 12-inch
Uconnect display, the ParkSense Active Park
Assist switch is located above the display.
To enable or disable the ParkSense Active Park
Assist system, push the ParkSense Active Park
Assist switch once (LED turns on). Pushing the
switch a second time will disable the system
(LED turns off).
The ParkSense Active Park Assist system will
turn off automatically for any of the following
conditions:
Parking maneuver is completed.

Vehicle speed is greater than 18 mph

(30 km/h) when searching for a parking
T
HE
space.
A
SSIST
Vehicle speed is greater than 5 mph (7 km/h)

during active steering guidance into the
parking space.
Steering wheel is touched during active

steering guidance into the parking space.
ParkSense Front/Rear Park Assist switch is

pushed.
Driver's door is opened.

Tailgate is opened.

Electronic Stability Control/Anti-Lock Braking

System intervention.
NOTE:
The ParkSense Active Park Assist system will
allow a maximum of eight shifts between DRIVE
and REVERSE. If the maneuver cannot be
completed within eight shifts, the system will
cancel and the instrument cluster display will
instruct the driver to complete the maneuver
manually.
The ParkSense Active Park Assist system will
only operate and search for a parking space
when the following conditions are present:
Gear selector is in DRIVE.

The ignition is in the ON/RUN position.

The ParkSense Active Park Assist switch is

activated.
Driver's door is closed.

Tailgate is closed.

Vehicle speed is less than 15 mph (25 km/h).

The outer surface and the underside of the

front and rear fascias/bumpers are clean
and clear of snow, ice, mud, dirt or other
obstruction.