Compaq WL110 User Manual page 55

Starting the Remote Link Test
To display the remote statistics for the Access Point, you must first connect to
the target Access Point as described in "Connecting to Access Points" on
page 5-18.
1. Select the
pictured in Figure 5-7.
The fields in the top section of this window identify the "initiator station"
you selected when connecting to the Access Point.
Figure 5-7 Select a Link Test Partner
The middle section of the "Select Remote Link Partne rfo r..." window
displays all wireless devices connected to the "initiator station". The
following fields are visible:
The fields
by their station name and MAC address respectively.
This list may change as roaming mobile stations enter or exit the
coverage area of the selected Access Point.
The
Interface
WL110 PC Card has been inserted.
— 2 = PC Card slot A
— 3 = PC Card slot B (for WL510 Access Point only)
The
Radio Type
slots):
— IEEE 802.11 for WL110 PC Cards
2. (Optional) To refresh the list, click the
3. Select a station from the list and click the
Remote Link Test window as pictured in Figure 5-8 on page 5-22.
tab and click the
System
and
Station Name
field identifies the slots of the Access Point into which the
field identifies the type of PC Card (in the corresponding
button to display the window
Link Test
these wireless devices are identified
Address
button.
Refresh
Link Test
Monitoring your 11Mbps Wireless LAN Network
button to display the
5-21