Compaq WL110 User Manual page 109

Access Point
BOOTP or DHCP server, this IP address is entered automatically).
Access Point
BOOTP or DHCP server, this IP address is entered automatically).
(optional)
(optional)
Points).
All parameters are explained in the next paragraphs.
3. When finished, proceed with configuring other parameters or click
save the configuration and return to the main A PManager window.
Figure 8-5 Setup Access Point IP Parameters
IP address
Each Access Point needs an unique IP address. Use either:
DHCP, to obtain an IP address automatically, or
manually enter an IP address
Note: All Access Points must have a unique IP address value to allow you to
address each Access Point specifically. Duplicate IP address values may
cause unexpected behavior of the network and/or negative impact on
network performance.
Manually assign an IP address
(unique for each Access Point, in case of a
"IP address"
(the same for all Access Points, in case of a
"Subnet Mask"
(usually the same for all Access Points).
Default router
(Time To Live) (usually the same for all Access
Default TTL
Advanced Network Configurations
to
OK
8-9