Compaq WL110 User Manual page 105

Enabling the spanning tree mechanism to resolve the closed network loops
errors (see "Spanning Tree" on page 8-7).
Storm threshold filtering to limit the number of messages per port and/or
station from being bridged (see "Storm Threshold" on pag e8-8).
CAUTION:The Bridge parameter settings are typical "common" parameters,
i.e. the Bridge parameter settings should be the same for all Access
Points.
Figure 8-1 Bridge Tab in the Edit Mode
To set the Bridge parameters, connect to the Access Point and select the
tab to display the bridge parameters as pictured in Figur e8-1.
Protocol Filtering
The filtered protocols are listed in the top section of the
set default of the Access Point is
transmitted to the wireless medium. This is the recommended setting when you
do not require specific protocols to be filtered.
To filter specific protocols, proceed as follows:
1. Determine the minimum set of protocols that must be bridged.
2. Click the
pictured in Figure 8-2.
button to display the Filter Ethernet Protocols window
Edit
which will allow all protocols to be
<None>
Advanced Network Configurations
Bridge
tab. The factory-
Bridge
8-5