Compaq WL110 User Manual page 138

Note: When importing a configuration file, make sure you import the correct
back-up file. Configuring the Access Point with a configuration file that
is identical to the configuration of another Access Point may lead to
unpredictable behavior of your network.
If you do have a back-up configuration file and if you do wish to use
this file to configure the Access Point, click
Select the back-up configuration file (*.cnf) and click
back-up configuration settings.
You are advised to check the configuration settings. Click
continue.
If you do not have a back-up configuration file, or if you do have a file
but do not want to use this file to configure the Access Point click
You are now advised to manually modify/verify the configuration
settings of the Access Point (i.e. assign a unique IP address, setup the
11Mbps Wireless LAN parameters and, (if applicable) the other Access
Point identifiers such as the IP Address and SNMP passwords).
7. The Edit Configuration window is displayed. Note that the Edit
Configuration window does not contain an
upload the configuration settings to the Access Point.This means that you
are editing a local configuration file and that you are not yet connected to
the Access Point.
8. View (and modify) the configuration settings in all tabs.
Refer to chapter 4 "Basic Network Configuration" for changing the
configuration settings.
9. Click the
Access Point in force reload mode.
The message "Please wait while trying to connect to the Access Point"
appears. While trying to connect to the Access Point, the IP address in the
configuration settings is pinged.
Only if the IP address specified in the configuration already exists, you
are prompted to enter a new IP address. If the IP address does not yet
exists the uploading continues.
Because the password of the Access Point in forced reload mode is
always "public", you do not have to enter this password before upload-
ing information to the Access Point.
10. When prompted to confirm the "Reload of the Remote System", click
continue.
The local software file ("wpntxxx.bin" or "ap05xxx.bin") will now import
the configuration settings and save these to the software (binary) file. The
software file will now be overwritten by the new software file. This does
Forced Reload Procedure
C-6
button to upload the new configuration settings to the
Upload
.
Yes
Open
button but an
OK Upload
to open the
to
Ok
.
No
button to
to
Yes