System Information - Compaq WL110 User Manual

Figure 5-6 System Information Window

System Information

The system information does not provide on-line statistics, but is primarily used
to verify the version level of the embedded software that is loaded into the
Access Point.
To display the system information for the Access Point, you must first connect to
the target Access Point (see "Connecting to Access Points" on pag e5-18).
Select the
System
The fields
entered in the corresponding fields of the
Access Point was configured.
If you would like to change these names, please consult the section about
configuring SNMP parameters as described in "SNMP Parameters" on
page 8-11.
The
Up Time
Access Point was reset. If the up time is lower than expected, the Access
Point may have been reset manually or rebooted automatically.
The fields
users. You will need these values and the contents of the
only when contacting Technical Support to report a problem.
Providing this information to your Technical Support representative will
help to determine the cause of the problem.
tab to view the system information.
, and
Name Location
field displays the time interval measured from the last time the
and
Services Object ID
represent the values that have been
Contact
SNMP
do not display relevant information to end-
Monitoring your 11Mbps Wireless LAN Network
tab in de edit mode when the
Description
field
5-19