Connecting To Access Points - Compaq WL110 User Manual

All other diagnostic options are standard SNMP tallies that are not described in
this manual, but documented in the on-line help system of your AP Manager
program.
Note: All diagnostic options are described in the on-line help information of
the AP Manager. To access that you can access by pressing the
function key or clicking the

Connecting to Access Points

To start monitoring the Access Point, you must first connect to the target Access
Point.
1. Start the AP Manager program.
2. Select the target Access Point from the local list or enter the IP address of
the Access Point that you wish to monitor.
Alternatively, you can select
menu to display all Access Points available in your subnet.
Note: Only Access Points in the same subnet as the management station are
displayed in the list. To investigate a link outside of the subnet, enter the
specific IP address in the
field.
3. Click
Monitor
4. The monitor mode of the AP Manager window is displayed as pictured in
Figure 5-6.
You can now monitor your network.
Monitoring your 11Mbps Wireless LAN Network
5-18
Refresh Access Point List
Enter the IP address of a specific
to connect to the target Access Point.
button in your A PManager window.
Help
F1
from the Access Point
Access Point