Chapter 2 Install Your Product; Plug In Signals; Plug In Main Power; Turn On Your Product - RGBlink Flexpro 8 User Manual

Chapter 2 Install Your Product

2.1 Plug in Signals

Connect signals to the product (ensure all the device are all power off first).Tighten
connector screws/locks where provided.

2.2 Plug in Main Power

Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.

2.3 Turn on Your Product

Turn on the power switch on the real panel.
OLED display will show as below,completing initialization before loading the latest settings
and input/output configuration.
The system begins to work,and the OLED module shows the input slot and output slot
information, device status, COM. Versions. IP address and serial number.

2.4 Connect Felxpro 8 and Computer

Use network cable to connect the Felxpro 8 and computer with USBA-B cable from In the
Box.
Set the IP address of the computer and make sure the computer and the device are in
same network range. IP address of the device is available on the OLED screen after it is
powered on. For example if the IP of the device is 192.168.110.1, just make sure the IP of
the computer is in 192.168.xxx.x, but not exact the same as the device.
Felxpro 8 User Manual
11