Push Bar And Draw Bars; Power Cord Of The Electronic Measuring Device (Optional); Electrically-Powered - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

After completing the connecting procedures,
check that all the connections are safe and secure!
NOTE! Before moving the log splitter, check that your tractor has enough capacity to
pull/lift the log splitter.
Always connect the cardan shaft on your own. The tractor cabin must be free of people
and animals in order to prevent accidental contact with the controls while the log splitter is
being connected to the tractor. Check all log splitter and tractor connecting devices before
connecting them. All faulty devices must be repaired or replaced. Never connect the log
splitter to a defective device or part. Carry out all connection procedures thoroughly and
carefully.

3.2 Push bar and draw bars

The pins that are used to connect
the push and drawbars to the log
splitter must be of the correct size,
and the appropriate locking pins
must be used to ensure that they
remain secure.

3.3 Power cord of the electronic measuring device (optional)

The cord must be
routed so that using
or moving the log
splitter cannot
damage it. Always
check the condition
and length of the
cord before and
after using
moving the log
splitter.
Check that the plug
is clean before
connecting it to the
tractor socket.
Hakki Pilke 42 Easy
or
Tractor-powered
10 (97)
Original
The socket of
the measuring
device of an
electrically-
powered log
splitter is
located at the
back of the
machine.
Electrically-
powered
Version 4