Cutting Mode; Controlling The Splitting System - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

10 CUTTING MODE

For information on the applicable controls, see points 5C, 5H, and 5G in Chapter 5 (p. 12-
13).
The 42 log splitter has hydraulic saw chain rotation.
Cutting mode prerequisites:
- The log splitter must be connected to a power source (see Chapters 3 or 4).
- The splitting and cutting guards must be in the operating position (Figure 820).
The blade flange is lowered with a hydraulic lever (5C, c2, p. 12). You can increase and
decrease the lowering force with a separate adjustment screw (5G, p. 12).
The saw chain also stops when the splitting or cutting guard is lifted (Figure 800).

11 CONTROLLING THE SPLITTING SYSTEM

For information on the applicable controls, see points 5d and 5e in Chapter 5.
The splitting system is highly automated. Splitting mode starts once a log has been cut
with the blade flange and the flange is being lifted. You can also start splitting mode with
the foot switch (5E, p.12).
Use the splitting mode control lever to reset the splitting mode or to stop the resetting.
(5D, p. 12).
Figure 111
Hakki Pilke 42 Easy
27 (97)
Original Version 4