Tightening And Changing The Flange, Blade Chain - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

20.6 Maintenance of the cutting flange and blade
Always wear gloves when handling the cutting blade. NOTE! THE MACHINE MUST BE
TURNED OFF AT ALL TIMES WHEN CARRYING OUT MAINTENANCE!

20.6.1 Tightening and changing the flange, blade chain

To make the job easier, you may turn the blade guard.
Remove the two screws from the input and output conveyors' side, indicated by arrows,
and turn the blade guard to the position shown in the figure.
Disconnect the machine from the tractor and power supply.
Figure 2061a
Tightening: Loosen the
blade flange's fastening
bolts (2 pcs), indicated by
the arrows, and tighten the
screw in the direction of the
flange with a chisel head
screwdriver, until the blade
chain is tight enough that
you can see three slot teeth
when lifting the chain from
the middle (Figure 2016c).
Hakki Pilke 42 Easy
43 (97)
Remove the 4 fastening bolts.
Use this screw to
loosen/tighten the
chain
Figure 2061c
Original
Use these screws to
fasten/unfasten the
blade
Version 4