Normal Splitting; Fixing Irregular Log Positions That Prevent Normal Splitting - Hakki Pilke Easy 42 Series Instructions For Assembly, Operation And Maintenance

15.2-7. If the log is correctly placed on the input conveyor and its shape is safe for cutting,
cut the log by holding the lever (5-C2) down until the log has been cut.
Figure 152

16 NORMAL SPLITTING

Splitting mode is turned on when the cutting blade returns from its lowest position. You
can also start the splitting mode by using the foot switch.

16.1 Fixing irregular log positions that prevent normal splitting

WARNING! If a fallen log is in an imbalanced, vertical, or some other position that
makes splitting impossible, you must proceed as follows:
16.1-1. Open the splitter guard.
16.1-2. Correct the position of the cut log so that it can be split.
16.1-3. Close the splitter guard.
16.1-4. Restart splitting mode using the foot switch.
After splitting, feed more logs into the cutter and continue processing.
Hakki Pilke 42 Easy
35 (97)
A cut log hits the log guide and is automatically
guided into the correct position for the groove.
WARNING! Always check that the cut logs are
positioned correctly for the groove (parallel).
Original Version 4