Advertisement
9/26/2018
Send Firmware Update
Start the Sysex Playback app. Load the MIDI le containing the rmware update, select
the MIDI port Thyme is connect to and start ashing.
The whole process will take over two minutes. Do not interrupt data or power connection
during ashing. Doing so may render your device unusable.
Hardware Tests
To test devices in our production the rmware contains self-tests. These tests are also
present in the production rmware so you can run them yourself if you think your unit might
be faulty.
Enter Test Mode
To run tests you have to boot your device into a dedicated test mode by holding down all
four
PATTERN
that you have entered test mode.
There are six different hardware tests which can be run in a row (to perform a general
check) or individually (to track down an error).
Run tests
To run a single test, hold down the
2 to run only test number 2) and press
press
alone.
PLAY
In case the selected single test(s) complete without an error, you will see a light travelling
through the
A failure is indicated by
LEDs ashing. Some tests also have individual failure indications that tell you more
details about what went wrong. They are displayed before the general indication.
When a test failed, it can be restarted by pressing
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
buttons while powering up the device. The four
LEDs and bouncing off the edges.
1-8
LED corresponding to the failed test being on and all knob
1-8
Thyme Manual
button corresponding to the desired test (Button
1-8
. To run all the tests 1 to 7 after another, just
PLAY
.
PLAY
LEDs indicate
PATTERN
46/48
Advertisement
