Bastl Instruments Thyme Manual page 32

9/26/2018
18
MIDI
Change Clock Source
You can change the clock source by holding down
the three options: Tap Tempo / Analog Clock / MIDI Clock.
While is being pressed the current clock source is indicated by the three LEDs above
FN
/
FREEZE LINK
The signal of the selected clock is permanently shown on the
For each clock source there are four divider options.
Tap
A 2 steps per tap
B 1 step per tap
C 2 substeps per tap
D 1 substep per tap
When the divider option is being changed, the sequencer will remain phase-aligned with the
input clock.
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
Using beat clock messages from MIDI input
/ in the order indicated below the
SYNC
Analog Clock
1 substep per edge
1 substep per 2 edges
1 substep per 4 edges
1 substep per 8 edges
Thyme Manual
and pressing
FN
button.
TAP
TAP
MIDI
8 substeps per quarter note
4 substeps per quarter note
2 substeps per quarter note
1 substep per quarter note
to cycle through
TAP
LED.
32/48