Advertisement
9/26/2018
Read MIDI Channel
When powering on the device, the knob LEDs will fade on and the current MIDI channel
will be displayed by the
When all LEDs are off but a single one is on, its position indicates a channel number from
1 to 8.
When all are on but a single one off, its position indicates a channel number from 9 to 16.
Set MIDI Channel
To change the channel keep one of these button combinations pressed while powering
up the device:
Channel 1-8:
Channel 9-16:
The new channel will be indicated right away, as described above.
Control Change
With Control Change Messages you can control all parameters of the selected Sound .
The data byte of any midi control message is interpreted in one of these ways.
Scale
Maps the received value to a different range.
In most cases, this will be the range you can set with the parameter knob. For
example Volume from off to full.
Select
Maps the range of the received value to a few discrete values.
For example select one out of eight Robot Modes with the values from 0 to 127.
Switch
Special case of Select with high values mean on and low ones off.
For example turn on/off Delay Sync if value is greater/smaller than 64
Trigger
Ignores the data byte. Only the fact that a message of this number has been
received triggers a certain action
Command
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
LEDs.
1-8
buttons
1-8
and
buttons
FN
1-8
Type
Description
Thyme Manual
25
41/48
Advertisement
