Advertisement
9/26/2018
Set Robot Phase
You can set the polarity of the selected Robot by holding down
pressing one of the four
current phase setting is indicated by an LED.
Robot Stereo Polarity
Normally, both stereo channels are processed equally. When you activate stereo polarity on a
Robot, it will in uence the left and right channel in the opposite direction.
For oscillator-type Robot Modes this means phase-shifting the waveforms for both channels
(on the left channel, the triangle oscillator is at its peak while it's in its valley on the right
channel), for Envelope and Control Voltage this means inverting the polarity (on the left left
channel the robot would add up to the knob value, on the right channel it would subtract). In
stereo polarity the LEDs of the knobs indicate the current parameter value for the left channel
only.
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
Thyme Manual
buttons. While
PATTERN
ROBOT SELECT
is being pressed, the
ROBOT SELECT
and
22/48
Advertisement
