Advertisement
9/26/2018
Select a Robot
All nine Robots work independently from each other and run simultaneously, but you can
only control one at a time. To select the one to control, press and hold down
ROBOT SELECT
The selected Robot will always be shown with full brightness. All other parameters will
display the output of their Robot.
To select a Robot for a different parameter, simply move the corresponding knob slightly.
The selection change is directly indicated by full brightness of the LED as explained
above.
The output of the selected Robot is permanently indicated by the dedicated Robot LED.
The Robot's modulation curve is mainly de ned by three parameters: Mode, Rate and Shape.
With Amount you can de ne how strong this modulation should be. Setting it to zero (fully
left) will turn off modulation by this Robot.
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
.
Thyme Manual
14/48
Advertisement
