Advertisement
9/26/2018
Set Robot Stereo Polarity
You can activate/deactivate stereo polarity of the selected Robot by holding down
ROBOT SELECT
LED will indicate the current status.
Volt-per-Octave
When Tape Speed or Delay Fine is modulated by external control voltage (by setting their
Robots to CV Mode), the voltage is not interpreted linearly but as volt-per-octave.
This means that when a steady voltage of 1V is applied to the jack, the tape speed or delay
length will be doubled , for 2V the factor will be four and so on .
Depending on the polarity setting the modulated parameter is multiplied or divided by the
factor de ned by the control voltage. The mapping is implemented in such a way that positive
polarity will in most situations increase the pitch (higher tape speed, shorter delay) and
negative polarity will reduce the pitch (lower tape speed, longer delay) .
https://bastl-instruments.github.io/thyme/manual.html#/Introduction
and pressing
ROBOT SYNC
14
Thyme Manual
. While
ROBOT SELECT
15
is being pressed, the
16
23/48
Advertisement
