Configuring The Iscsi Initiator With Target (Reo Device) And Initiator Assignments - Overland Storage REO Series Setup Manual

Overland Storage REO 4000™ with Protection OS™ Software
6
Configuring the iSCSI Initiator with
Target (REO Device) and Initiator Assignments
94 Associating Targets (Devices) and Initiators
Tip: You can select multiple targets.
d When the message appears that indicates all connections will be reset,
click OK to continue.
Repeat these steps for each target.
On each applicable server, use the management tool that came with your
iSCSI initiator to specify the target (REO Device) information.
To configure the REO Appliance as a backup-and-recovery appliance, you
must provide target (REO Device) and initiator (host) information. An
iSCSI name (for iSCSI) or a set of WWNN and WWPN names (for FC) is
required for both the targets and the initiators. After targets and
initiators have been specified, they must be assigned to each other. This
must be performed on the server by using the software or hardware
initiator, and on the appliance by using the REO GUI, which you
completed in the previous section.
Note: For detailed information on various drivers and adapters, see the
manufacturer's documentation for assistance on assigning targets.
You can also check the Overland Web site (www.overlandstorage.com)
for Application Notes.
Select FC, enter the
node and port
names for the
initiator, select the
ID, and click Submit.