Battery Extraction; Figure 10: Ejector Latch; Figure 11: Remove Battery - Mellanox Technologies MIS5600Q-10DNC Dismantling Manual

Rev 1.1
4. Remove the bottom cover.
5. After the cover is removed unscrew the 4 Philips screws and remove the board from the
casing.
6. Remove the heat sink from the board by unscrewing the 4 slotted screws and remove the
heat sink from the board.
2.6

Battery Extraction

In all Mellanox Management boards, there is a: COIN TYPE LITHIUM BATTERY CR1620
3V 75MA.
12
Management Module /Spine
Management Module /Spine
Remove the
battery

Figure 10: Ejector Latch

Figure 11: Remove Battery

Extraction of the Modules