BMW M3 SEDAN Owner's Manual page 327

When the tire pressure does not reach at
least 2 bar, contact a manufacturer service
center or another qualified service center or
repair shop.
When a tire pressure of at least 2 bar is
reached, see Minimum tire inflation pressure
is reached.
6. Unscrew the connection hose of the com‐
pressor from the tire valve.
7. Pull the connector out of the power socket in
the vehicle interior.
8. Stow the Mobility System in the vehicle.
Minimum tire inflation pressure is
reached
1. Unscrew the connection hose of the com‐
pressor from the tire valve.
2. Pull the connector out of the power socket in
the vehicle interior.
3. Stow the Mobility System in the vehicle.
4. Immediately drive approx. 5 miles/10 km to
ensure that the sealant is evenly distributed in
the tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Adjustment
1. Stop at a suitable location.
2. Screw the connection hose of the compres‐
sor directly onto the tire valve stem.
Online Edition for Part no. 01405A1E4B0 - X/20
Wheels and tires
3. Insert the connector into the power socket in
the vehicle interior.
4. Correct the tire inflation pressure to at least
2.0 bar:
▷ Increase tire inflation pressure: with
standby state or drive-ready state
switched on, switch on the compressor.
▷ Reduce tire inflation pressure: press the
button on the compressor.
5. Unscrew the connection hose of the com‐
pressor from the tire valve.
6. Pull the connector out of the power socket in
the vehicle interior.
7. Stow the Mobility System in the vehicle.
Continuing the trip
Do not exceed the maximum permissible speed
of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor.
Reset the Tire Pressure Monitor again.
Replace the nonworking tire and the sealant con‐
tainer of the Mobility System promptly.
Additional information:
▷ Run-flat tires, refer to page 334.
▷ Tire pressure monitor, refer to page 328.
MOBILITY
327