BMW M3 SEDAN Owner's Manual page 293

If the mobile phone does not support the Qi
standard, the mobile phone can be charged
using a special Qi-compatible charging case.
▷ Standby state is switched on.
▷ Observe the maximum dimensions of the
mobile phone.
▷ Use only protective jackets and covers up to
a maximum thickness of 0.07 in/2 mm; other‐
wise, the charging function may be impaired.
▷ The mobile phone to be charged is located in
the center of the tray.
Manual transmission: storage in
the center console
Inserting the mobile phone
The size of the mobile phone must not exceed a
maximum of approx. 5.9 x 3.6 x 0.62 in/150 x
91.5 x 16 mm.
1. Open the center armrest.
2. Depending on the thickness of the mobile
phone, pull the car mount out on the bottom,
arrow 1. If necessary, swivel out the upper
edge, arrow 2.
Online Edition for Part no. 01405A1E4B0 - X/20
Interior equipment
3. Slide the mobile phone with the display on
the side of the clamp into the tray.
4. Close the center armrest.
Removing the mobile phone
1. Open the center armrest.
2. Remove the mobile phone.
Steptronic transmission: storage
in the center console
Inserting the mobile phone
The mobile phone must not exceed the maxi‐
mum size of approximately 6.0 x 3.1 x
0.7 in/154.5 x 80 x 18 mm.
1. Open the tray cover.
2. Place the mobile phone centered in the tray
with the display facing up.
3. Close the tray cover.
Removing the mobile phone
1. Open the tray cover.
2. Remove the mobile phone.
CONTROLS
293