BMW M3 SEDAN Owner's Manual page 195

Warnings are issued by means of a steering
wheel vibration. The severity of the steering
wheel vibration can be adjusted.
The system does not provide a warning if the
turn signal is set in the respective direction be‐
fore leaving the lane.
Depending on the equipment version, if in the
speed range up to 130 mph/210 km/h a lane
marking is crossed, the system may intervene
with a brief active steering intervention in addi‐
tion to vibrating. The system thus helps keep the
vehicle in the lane.
Safety information
Warning
The system cannot serve as a substitute for the
driver's personal judgment in assessing road
and traffic safety. There is a risk of accident.
Adjust driving style to traffic conditions. Watch
traffic closely and actively intervene where ap‐
propriate. Do not jerk the steering wheel in re‐
sponse to a warning.
Warning
Indicators and warnings cannot serve as a sub‐
stitute for the driver's personal judgment. Due
to its limits, the system may not issue warnings
or reactions, or these may be issued late or in a
manner that is not consistent with their normal
use. There is a risk of accident. Adjust driving
style to traffic conditions. Watch traffic closely
and actively intervene where appropriate.
Functional requirement
The camera must detect the lane markings for
the lane departure warning to be active.
Online Edition for Part no. 01405A1E4B0 - X/20
Safety
Overview
Button in the vehicle
Intelligent Safety
Sensors
The system is controlled by the following sen‐
sors:
▷ Cameras behind the windshield.
Additional information:
Sensors of the vehicle, refer to page 35.
Switching on/off
Switching on automatically
The lane departure warning activates automati‐
cally after departure if the function was switched
on at the end of the last trip.
Depending on the national-market version, the
system is automatically active after every driving
off. The base setting is thereby activated.
Switching on manually
Press the button.
The menu for the Intelligent Safety sys‐
tem is displayed.
If all Intelligent Safety systems were switched off,
all systems are now switched on.
"Configure INDIVIDUAL": depending on the
equipment version, the Intelligent Safety sys‐
tems can be individually configured. The individ‐
ual settings are activated and stored for the
CONTROLS
195